Peugeot 308 Key Fob Replacement

Peugeot’s 308 might be getting on a bit, but it still feels attractive. It might not be the most luxurious car in its class but the Ford Focus or Volkswagen Golf will shield you from sloping surfaces – but it’s still a pleasant and comfortable driving experience.

We often receive requests from Coded Car Keys to replace peugeot key fobs. Whether the problem is ongoing or continuous the following suggestions should aid.

Water Damage

If you accidentally drop your key fob into an eddy, or it gets wet while kayaking canoeing, rafting, or canyoning the fob is more likely to be damaged by water. The best way to avoid this from happening is to keep it in a dry container when you’re outdoors or performing things where the fob might be exposed to a lot of water.

It’s also crucial to ensure sure that the fob has dried out before you open it up and then use it again. If you notice any odors emanating from the fob like an industrial liquid smell or that of windshield washer fluid, this is another indication that it’s submerged in water.

A circuit board that’s damp can cause the battery to dump its charge, or even explode. If you are able to get your keyfob 308 from the water and turn it upside up and shake as much water as possible before opening the casing. After opening it, take out the battery and wipe the circuit board with the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.

Other reasons your Peugeot 308 remote keyless entry system may not function include a dead coin battery or receiver module issue signal interference, an electronic chip malfunctioning. If none of these are the issue, you can reset the system by removing the 12 voltage battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote start system that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to getting in. This feature is extremely helpful, especially during cold winter months. However, there are times when the remote start system stops working due to a variety of causes, such as a dead coin battery.

A coin-shaped battery located inside the key fob can last for a period of between two and four years, based on how often it’s used and the location where it was purchased. The date of use is typically found on the packaging or in the manual.

If the key fob stops working after exposure to pure tapwater, you need to remove the battery and clean the electronic chip with the aid of a towel soaked in isopropyl ethanol. Then dry the chip completely before replacing. If you expose it to salty or soapy water, the chip may be fried and you will require replacing the key fob entirely.

If you’re not sure the battery is defective You can test its voltage with a multimeter set to your car’s voltage range, and connect it to the plus and minus terminals. The voltage should be between 12 to 13 volts, but if it is lower, the battery should be replaced. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. ( G28 Car Keys ). The engine should then start after this.

Faulty Receiver Module

If you don’t see the „Key Detected”, it could be the receiver module not working properly. It’s the part that sends out the signal when your key fob turns on. It also acts as an alarm and blocks the vehicle from starting without the correct key.

The cause could be many causes, such as water damage or just aging. If your Peugeot 308 key fob has been exposed to dirty tap water, for instance the electronic chip inside may be damaged. In this case you will have to take it off and thoroughly clean it using isopropyl or electronic cleaner. When the battery is clean you can attempt to test it again.

If the issue isn’t resolved you’re probably in need of a option to consult an area Peugeot specialist or locksmith. They’ll employ a diagnostic tool identify the issue and repair it for you.

It is stressful to lose your Peugeot car key. A professional auto locksmith will be able to solve the issue in a matter of minutes. They can cut a new key and program it to your vehicle, ensuring that you’re out on the road as quickly as possible. Click here to find a locksmith in your area.

Faulty Electronic Chip

The electronic chip in your Peugeot 308 key fob is an crucial component of the remote control system. If it gets damaged, your car may not start, or you could receive a message saying „anti-theft active”. If this happens, the only way to fix the problem is to purchase a new key. Fortunately, professional auto locksmiths can offer the service in the shortest amount of time.

The chip in your Peugeot 308 key fob can be damaged by water damage, sweat, dirt or other reasons. If your Peugeot key fob has been exposed dirty or soapy water, it needs to be cleaned right away. You can use a paper towel and isopropyl alcohol to clean the electronic component. The battery must then be allowed to dry completely.

Radio interference can cause the key fob to stop working. This can happen when other devices operate on the same frequency as your Peugeot keyfob. It could also be caused by weather conditions or objects that are in the vicinity of the vehicle. It is recommended to see a Peugeot dealer in the event of this issue.

The Peugeot 207/308 Key Fob is very delicate and requires special attention. You shouldn’t drop it or throw it around. If you lose it, try to find it as soon as you can. You can reset your on-board computer by disconnection of the battery for a few minutes. Be sure to disconnect the negative cable first, and then the positive.